|
Cut the PARAS SWR pipe
to the required length.
|
Chamfer the edge of the
pipe Clean all the dirt &
dust, make sure that the
spigot and socket are thouroughly clean and dry.
|
Apply PARAS Rubber lubricant
on the external surface of the chamfered end of
the pipe
and on the rubber gasket.
Fit the rubber ring in to the groove of the pipe.
|
|
Confirm that ring seal is
in position in the housing.
|
Push the pipe fully into
the socket and mark the
pipe depth in the socket
using the marker.
|
Pull out the pipe by 12mm
from the socket register.
This is very important it
take care of thermal
expansion and contraction.
|
